Type: 3/4" Pulse Output Gas Meter
Mounting: Outdoor Mount
Units: Cubic Feet
Pulse Output: 1 Pulse Per Cubic Foot
Dimensions: 10" Tall x 7.5" Wide x 6.5" Deep
Read your gas usage remotely too! Our Pulse Output Gas Meters operate like a normal gas meter. They also have the ability to be read remotely. For every cubic foot of gas that is metered, this gas meter produces an electrical pulse. These pulses can be measured and counted by our EKM Omnimeter Pulse v.4, which is our new pulse counting electric meter. This pulse counting meter has the ability to count pulses from up to three pulse-output devices. It also has the ability to control up to two relay switches. This allows you to turn thing on and off remotely.
When connected to a v.4 Omnimeter, the gas meter can send pulse data the cloud with our EKM Push communication system. The EKM Push sends all of your meter data to our cloud database and inserts it into your personal account, where you can access it for free. In other words, with this system you can easily monitor gas usage, at an unlimited number of sites around the world, for free.
Remote Gas Reading:
You can use this meter to measure natural gas, gaseous propane (not liquid), air, or any other non-corrosive gas.
Simple 2-wire connection between gas meter and kWh meter.
No additional power source is required.
Pulse count can be read remotely using the our free, remote reading, EKM Dash software.
Very reasonably priced gas meter, even if the pulse output is not used.
1 Pulse Per Cubic Foot (approx. 1 pulse per 0.0283 cubic meter).
- Minimum operating pressure: 0.0725 PSI
- Maximum operating pressure: 7.25 PSI
- Permissible Error: Qmin≤Q<0.1Qmax ± 3%, 0.1Qmax≤Q≤Qmax ±1.5%
- 1 pulse per 1 cu ft.
- Min. Recording numeric: 0.2
- Max. Recording numeric: 9999999.9
- Max. Flow: 211 ft³/ hour (Propane: 524,968 BTU/ hour at 60ºF, temperature dependent)
- Readout is in cubic feet, with resolution to tenths
- Operating ambient temperature C: -20~50
- Service life: 12 years
- Suitable gas: Natural gas, gaseous propane (from top of tank), artificial coal gas, air, or other inert gases
Due to the physical size of the gas meter, we will ship orders with gas meters via USPS Parcel Select.
For more information about our products and services, we encourage you to visit our online Knowledge Base, which provides spec sheets, videos, tutorials, FAQs, diagrams, and more.
Spec Sheet: 3/4 inch Pulse Output Gas Meter Spec Sheet .pdf
- Additional Information
- Questions and Answers
Questions & AnswersExpand allCollapse allSort byMost Recent QuestionsQ:What is the dimensions of the gas meter? I want to use it to separate between my house and the separate apartment use for billing.1 answersQ:How do these meters calculate to therms which is what the gas company generally bills us by, NOT cu ft.? Water is generally billed by cubic foot, at least it is in the SE.1 answersQ:What are the btu capacities of your gas meters?1 answersQ:How far can I run the wiring from the metering device to the gas and water sensors?
Can I read data from other plc with modbus rtu or modbus tcp/ip?
1 answersQ:Will meter function without the remote wiring connected? Would like to use device to measure gas usage to separate gas units from main gas line.1 answersQ:Where this is installed there is NO WIFI. How do these connect to the remote display?1 answersQ:If I purchase six gas meters and want to remotely read the usage of each, how many v.4 Omnimeters do I need to purchase? All six? I read in the spec sheet, each one can read up to three gas meters?1 answersQ:This might be a stupid question but can you install this meter sideways?1 answersQ:Does this unit come with a mounting bracket, either wall or stand?1 answersQ:is this product UL listed and GRS listed?1 answersQ:With respect to installation, is there a specific amount of pipe distance required before and after the meter?1 answersQ:I have a gas meter but the pulse output wire is too short. Is there a way to extend it?1 answersQ:I would like to get pricing on a 3/4" gas meter that I can remote read and information on how to do this.1 answersQ:How long do the pulses last? Longer than 1 sec?1 answersQ:Can these be installed indoors next to the furnace? Do they require any extra ventilation?1 answersQ:I have a 2-1/2" gas line that I want to pulse meter. Do you have any products available for this?1 answersQ:Can you tell me the conversion for metering liquid propane? Is it simply converting cubic feet to gallons?1 answersQ:I have a duplex with two water heaters and one furnace. I would like to meter the gas use for each apartment separately. How would I accomplish this?1 answersQ:I have a detached garage that I turned into a studio. I would like to meter the natural gas and electric that is going out there. What products would be best to do this?1 answersQ:I have a 3 unit residential property with 1 natural gas meter. I can't split the property because I only have 1 hot water heater, but I have 3 furnaces.
Would this unit work to measure the gas used by each furnace? I'd like to set the rents to include gas up to a certain point, and then charge for overages by apartment.
- Installer Directory
Customer Reviews 2 item(s)
- First worked so well, I'm buying a second!
Functions exactly as advertised! I am measuring Helium gas near a high magnetic field so I did have to be careful about the field strength the unit is subjected to, but it has operated flawlessly! The pulsed output is very easy to monitor with minimal additional hardware.
Quality Price Value
- One paid for itself right out of the gate
I'm building a kitchen behind my house and wanted to track my Utility usage separately. I bought two Gas meters because we're on Propane and I had no meter other than the Gallon meter on the main tank.
On 30 May, our tank was nearly 30% full (70 Gals), when I had the Gas company install both meters, along with new Regulators. Since the kitchen wasn't ready, the Omnimeter wasn't active, but the meter to the house began tracking Gas usage at the immediately.
On 30 June, we totally ran out of Gas, which has never happened in 20 years. We had them come out and check for leaks and they found both new regulators had leaked 70 Gals of Propane in 30 days.
The moral of the story? Because I could convert the meter into Gallons, I was able to show them exactly what the amount of gas we had used in that timeframe (20 Gals) and was credited for 50 Gallons. I know if I didn't have the proof of usage from the Gas Meter, they would've been arguing that we must've used most of the 70 gallons. LPG gas was 2.30/Gal or $115 credited back to us.
Can't wait to get the rest of the system on (Electric, Water, Kitchen Gas)!
Price Value Quality
You may also be interested in the following product(s)